Single top partner production in the tZ channel at eγ collision in the littlest Higgs model with T-parity

Introducing the top partner is a common way to cancel the largest quadratically divergent contribution to the Higgs mass induced by the top quark. In this work, we study single top partner production in the tZ channel at eγ collision in the littlest Higgs model with T-parity(LHT). Since it is well known that polarized beams can enhance the cross section, we analyze the signal via polarized electron beams,and photon beams. we have selected two decay modes for comparison, based on the leptonic or the hadronic decays of the W and Z from the top partner. We then construct a detailed detector simulation, and choose a set of cuts to enhance signal significance. For mode A(B), the capacity for exclusion in this process at s~(1/2)=3TeV is comparable to the current experimental limits with L=1000(500) fb~(-1). If the integrated luminosity can be increased to 3000 fb~(-1), the top partner mass+mTcan be excluded up to 1350(1440) GeV at 2σ level. We also considered the initial state radiation effect, and find that this effect reduces the excluding ability of the eγ collision on the the top partner mass by approximately 10 GeV. Moreover, the ability to exclude the LHT parameter space at eγ collision complements the existing research.     

量子垒生长速率对InGaN基绿光LED性能的影响

利用MOCVD技术在图形化Si(111)衬底上生长了InGaN/GaN绿光LED外延材料。在GaN量子垒的生长过程中,保持NH3流量不变,通过调节三乙基镓(TEGa)源的流量来改变垒生长速率,研究了量子垒生长速率对LED性能的影响。使用二次离子质谱仪(SIMS)和荧光显微镜(FLM)分别对量子阱的阱垒界面及晶体质量进行了表征,使用电致发光测试系统对LED光电性能进行了表征。实验结果表明,垒慢速生长,在整个测试电流密度范围内,外量子效率(EQE)明显提升。我们认为,小电流密度下,EQE的提升归结为量子阱晶体质量的改善;而大电流密度下,EQE的提升则归结为阱垒界面陡峭程度的提升。     

真空条件下LiCl溶液蒸发量随浓度变化规律研究

除湿溶液再生是除湿空调系统的核心过程,为了提高除湿溶液再生效率,以蒸发量作为评价标准,在不同的真空度下对不同浓度LiCl溶液进行再生。对不同再生条件下,溶液的再生情况进行数学模拟及实验研究,并将模拟结果与实验结果进行对比分析,结果表明,实验结果同模拟结果具有相同的变化趋势。在6 kPa和8 kPa的压强下,LiCl溶液的蒸发量随浓度的增大先上升后下降,而在1 kPa的压强下,LiCl溶液的蒸发量随浓度的增大呈现出先下降再升高接着又下降的趋势。     

超越SNOM探针通光孔径尺寸的金属纳米间隙超分辨测量

采用电磁场有限元方法,数值模拟了孔径型扫描近场光学显微镜(aperture Scanning Near-field Optical Microscopy,a-SNOM)在照明模式下的工作过程.针对金偶极天线结构,改变天线长度和纳米间隙尺寸,计算了a-SNOM探针孔径的远场辐射速率随探针端面中心坐标变化的扫描曲线,实现了超越a-SNOM探针通光孔径尺寸的天线金属纳米间隙的超分辨测量,对于100nm通光孔径的探针,可分辨最小尺寸为10nm(0.016倍波长)的金属间隙.通过对比金属和介质偶极天线的a-SNOM探针远场辐射速率测量的计算结果,表明天线金属纳米间隙的超分辨测量的实现是由于金属间隙表面等离激元的激发.     

Stochastic delay foraging arena predator–prey system with Markov switching

Abstract

In this paper, we introduce white noise, telegraph noise and time delay to the two-dimensional foraging arena population system describing the prey and predator abundance. The aim is to find out how the interactions between white noise, telegraph noise and time delay affect the dynamics of the population system. Firstly, the existence of a global positive solution is verified. Then the long-time properties including the stochastically ultimate boundedness, extinction and some other asymptotic pathwise estimation of this population system are studied. Finally, the main results are illustrated by two examples.     

具有非线性传染率和时滞的随机SIQR计算机病毒模型的渐近行为

研究了一类具有非线性发生率和时滞的随机SIQR计算机病毒模型.首先证明了该系统具有唯一的全局正解,然后通过构造适当的Lyapunov函数并利用伊藤公式,分析了该模型的解在无病平衡点附近及地方病平衡点附近的渐近行为,最后通过数值模拟对随机系统解的渐近行为做了进一步的分析并给出了结论.     

Readjustment of the Bohr stopping force from energies of keV/n to a few tens of MeV/n ions in elemental targets

An analytical approach for the electronic stopping force for non-relativistic energies that has no adjustable parameters has been developed. The approach combines the Bohr model for the close collisions and the Firsov model for the distant collisions. In order to combine the two models, a probabilistic model was introduced. We have applied our model to ¹⁶O in ¹²C, ¹⁶O in ²⁷Al, ⁸⁴ Kr in ²⁷Al, ⁵Li in ¹²C, ¹²C in ¹²C, and ¹³²Xe in ¹²C systems and compared with SRIM/MSTAR software, the original Bohr model, the Firsov model and available experimental data. We have found that the calculated electronic stopping force values are in agreement with the general qualitative behaviour of the electronic stopping force as a function of particle velocity reported in the literature. The proposed analytical formula is expected to be valid for other projectile-target combinations but more experimental data are needed to verify this assumption.     

基于激光雷达的垂直能见度反演算法及其误差评估

针对大气垂直方向上消光系数分布不均匀难以用传统方法直接测量垂直能见度的问题,提出了一种基于激光雷达探测垂直能见度的计算方法。根据大气辐射传输基本原理,借助于辐射传输方程,推导出了垂直能见度的计算公式;然后利用激光雷达原理方程和Klett算法反演出大气垂直方向上的消光系数分布,基于此提出了垂直能见度的迭代算法。最后,利用灰色模型GM(1,1)和批统计算法,对激光雷达反演得到的后向散射系数进行了评估,给出了误差置信区间为(0.760±0.339)×10^-4(srad·km)^-1。结果表明,该方法是一种特别有效的计算垂直能见度的方法,符合探测的基本需求,且误差小精度高。     

241Am-Be中子参考辐射的蒙特卡罗模拟研究

研究用于校准场所中子剂量监测仪表的241Am-Be中子参考辐射场计量特性。采用蒙特卡罗方法模拟了空气自由中子参考辐射(FRNR),GB/T 14055规定的最小尺寸中子参考辐射(SRNR)和实际中子参考辐射(ARNR)中不同检验点处中子周围剂量当量率、散射中子占比和能谱分布特征。研究结果表明,空气对FRNR中的剂量率和能谱分布影响小,近似为理想中子参考辐射;采用5%含硼聚乙烯作屏蔽的最小尺寸SRNR可减少热中子,降低散射中子占比,影锥法不适用于小尺寸中子参考辐射中对散射中子的修正;ARNR中的散射中子更少、占比更低,影锥法所得散射中子占比与理论值基本一致。     

Investigation on the effect of density ratio on the convergence behavior of partitioned method for fluid–structure interaction simulation

In order to investigate the effect of density ratio of fluid and solid on the convergence behavior of partitioned FSI algorithm, three strong-coupling partitioned algorithms (fixed-point method with a constant under-relaxation parameter, Aitken’s method and Quasi-Newton inverse least squares (QN-ILS) method) have been considered in the context of finite element method. We have employed the incompressible Navier–Stokes equations for a Newtonian fluid domain and the total Lagrangian formulation for a non-linear motion of solid domain. Linear-elastic (hyper-elastic) model has been employed for solid material with small (large) deformation. A pulsatile inlet-flow interacting with a 2D circular channel of linear-elastic material and a pressure wave propagation in a 3D flexible vessel have been simulated. Both linear-elastic and hyper-elastic (Mooney–Rivlin) models have been adopted for the 3D flexible vessel. From the present numerical experiments, we have found that QN-ILS outperforms the others leading to a robust convergence regardless of the density ratio for both linear-elastic and hyper-elastic models. On the other hand, the performances of the fixed-point method with a constant under-relaxation parameter and the Aitken’s method depend strongly on the density ratio, relaxation parameter selected for coupling iteration, and degree of deformation. Although the QN-ILS of this work is still slower than a monolithic method for serial computation, it has an advantage of easier parallelization due to the modularity of the partitioned FSI algorithm.